Bosch Rexroth SHA Series, Руководство по эксплуатации

Страница: 34 / 94

Major potential differences!
Danger of destruction of electrical compo‐
nents by connecting or disconnecting con‐
nectors under voltage.
NOTICE
● De-energize the relevant system part before installing electrical compo‐
nents or when connecting and disconnecting connectors.
Prior to the installation, make sure the documents required according to
chapter 1.2 "Required and supplementary documentation" on page 5 are at
hand.
7.2 Unpacking
Parts falling out!
Risk of injury! If the packaging is opened im‐
properly, parts may fall out and cause injuries
or damage to the parts.
CAUTION
● Put the packaging on level, bearing ground.
● Only open the packaging from the top.
● Dispose of the packaging in accordance with the national regulations of
your country.
7.3 Installation conditions
7.3.1 Drive unit
● The components mounted to the drive unit must not be subjected to any
mechanical loading (e.g. impact). The connectors and mating connec‐
tors must be protected against such loads.
● Make sure that the drive unit and particularly the attached components
are not damaged during the installation.
● When installing the drive unit, always observe the ambient conditions
specified in the technical data.
● The dimensions are shown on the installation drawing. When determin‐
ing the required space, take the installation orientation into account.
● Please ensure during installation that in later operation sufficient air cir‐
culation will be provided to prevent overheating.
● The drive unit must be mounted on a ground with sufficient load bearing
capacity.
7.3.2 Drive controller
The drive controller and its accessory components have to be mounted ac‐
cording to the project planning description of Rexroth IndraDrive systems.
You can find the corresponding documents in chapter 1.2 "Required and
supplementary documentation" on page 5 .
Generally, the drive controller produces an increased leakage
current. If the drive controller is to be operated with a residual-cur‐
rent circuit breaker, type B or type B+ should be used. Otherwise,
spontaneous triggering may occur.
Bosch Rexroth AG Operating Instructions 32/91
Self-contained servo-hydraulic linear axis Type SHA...
Installation