4.5
Wrap-around
When you use the up and down buttons to change a digit or character on the display, the digit or
character will 'wrap-around' between its minimum and maximum values. For example, when
you enter a password digit, if the digit is '0' and you press the down button, the digit will change
to '9'; if the digit is '9' and you press the up button, the digit will change to '0'.
4.6
Timeout
As supplied, after you have entered a menu (other than the Normal menu), if you do not press a
button for five minutes, the Pump Display Module will automatically exit the current menu and
enter the Normal menu. This facility (known as timeout) is available so that if the setup or service
menu is entered and then the iL system is accidentally left unattended for a specified time, the
menu is exited to prevent unauthorised use of the menu options.
4.7
Menu structure
The menu structure is shown in Table 4-1. Note that if a particular system component or
accessory is not fitted, the corresponding menu option or parameter is not shown or is shown as
'NP' (not present). For example, in the Status menu (Figure 4-6), if a component is not fitted, 'NP'
(not present) is shown in the corresponding display line; so, if the iL system does not have an oil
monitor fitted to the LCDP pump, where Figure 4-6 shows the 'DP OIL' status display, the actual
display line will be 'DP OIL
NP'.
Note also that there are menus which, though programmed into the software in the iL system,
have no effect on iL operation.
4.8
Example
Here is an example of how to interpret the menu diagrams. The following procedure describes
how to change the units displayed for pressures (you can select kPa or psi).
1.
Press the Setup button to enter the Setup menu (Figure 4-8).
2.
Use the up and down buttons to change the first digit of the setup password to the correct
value, then press the ENTER button.
3.
Use the up and down buttons to change the second digit of the setup password to the correct
value, then press the ENTER button.
4.
Use the up and down buttons to change the third digit of the setup password to the correct
value, then press the ENTER button.
5.
If you have entered the correct password, the display will then show 'SETUP MENU' on the
top line and 'Inlet Purge' on the bottom line.
6.
Press the down button six times or press the up button five times; the display will then show
'SETUP MENU' on the top line and 'Units' on the bottom line.
7.
Press the ENTER button; the display will then show 'Units Select' on the top line and
'Pressure' on the bottom line (see Figure 4-10).
4-4
iL Dry Pumping Systems
Содержание iL600
Страница 18: ...iL Dry Pumping Systems 1 9 Figure 1 3 Schematic diagram of the electrical system...
Страница 21: ...1 12 iL Dry Pumping Systems Figure 1 4 Services and electrical connections on the rear of the iL system...
Страница 23: ...1 14 iL Dry Pumping Systems Figure 1 5 Electrical components shown without enclosure for clarity...
Страница 71: ...3 28 iL Dry Pumping Systems...
