BOC Edwards iL600, Инструкция по эксплуатации

Страница: 104 / 146

5.4 Start-up
WARNING
Do not operate the iL system with any enclosure panels removed and do not touch any
parts of the pump(s) when the iL system is on. Surfaces of the pump(s) are very hot
and can cause injury to people.
WARNING
Ensure that it is safe to start the iL system. If you do not (and, for example, maintenance is
being performed on components downstream of the iL system), you could cause injury to
people.
Note: When you use the Pump Display Module to start up the iL system, we recommend that you do not
disconnect the Module from the iL system; if you do, you will not be able to use the Module to
instantly shut down the iL system: see Section 5.3.
1. Switch on the cooling-water supply, the nitrogen supply on sensor configured systems, and
the external electrical supply (if not already on).
2. Ensure that the exhaust-extraction system is not blocked and that valves in the
exhaust-extraction system are open.
3. Ensure that the Pump Display Module has control of the iL system: refer to Section 5.3.
4. Refer to Figure 1-7. Look at the display (2) on the Pump Display Module:
•
If there are any warnings or alarms, take the necessary corrective action (refer to
Section 6); do not start the iL system.
•
If there are no alarms or warnings displayed, use the Switch On menu to switch on the iL
system.
When you switch on, the following actions will occur (with a small time delay between each
action):
•
The LED on the On button on the Pump Display Module will start to flash.
•
The LCDP pump will be switched on.
•
The LED on the On button on the Pump Display Module will stay permanently on.
•
The solenoid valve in the Gas Module will open to switch on the nitrogen supply to the
LCDP pump.
•
On iL600 systems, after the booster start delay, the LCMB pump will be switched on.
iL Dry Pumping Systems 5-3