BOC Edwards iL600, Инструкция по эксплуатации

Страница: 72 / 146

4 PUMP DISPLAY MODULE MENUS AND DISPLAY FORMATS
4.1 Introduction
The menus used and the display messages shown on the Pump Display Module are described in
the menu diagrams in Figures 4-2 to 4-19. The following symbols and conventions are used in the
menu diagrams:
These are flow lines. Arrows on the lines show the direction of
flow through a menu.
This symbol is used to connect different menus and shows the
starting point (or continuation point) of a menu. The symbol is
shown with the menu name and, where applicable, a reference of
the form [4-x/y]. This reference specifies that the menu continues
on (or is continued from) a menu shown on sheet y of Figure 4-x.
The sheet reference (/y) is omitted where it is not necessary.
This symbol is used for the ENTER and CANCEL buttons and the
four menu buttons: Normal, Status, Control and Setup.
This symbol is used for the up (
▲
) and down (
▼
) buttons and for
the on ( ) and off ( ) buttons.
This symbol is used for the two-line display on the Pump Display
Module. With the exception of variable text (see Section 4.4), the
text shown in the symbol is the text that will be shown on the
display.
This symbol is a subroutine box and is used to represent a
'subroutine call'; a subroutine is a series of menu steps which are
used in a number of different menus or used in different parts of
one menu. The [4-x/y] reference (used as described above) shows
where the subroutine is expanded.
In a menu which 'calls' a subroutine, where a menu flow line meets
the left hand side of a subroutine box, this means that flow
continues at the start connector (identified by <name>) of the
subroutine.
At the 'exit' connector of the subroutine, flow
continues in the (calling) menu along the flow line to the right of
the subroutine box.
This symbol shows additional text which is not part of the menu,
but which further describes the operation of the menu.
iL Dry Pumping Systems 4-1
☞
[4-x/y]
<Name>
∆