BOC Edwards iL600, Инструкция по эксплуатации

Страница: 44 / 146

3 INSTALLATION
3.1 Safety
WARNING
Obey the safety instructions given below and take note of appropriate precautions.
If you do not, you can cause injury to people and damage to equipment
•
Ensure that the iL system is suitable for your application: refer to Section 1.2.2.
•
You must not use the iL system in an application where incompatible gases are pumped, one
after the other. If you do, the gases will mix in the gearbox(es).
•
A suitably trained and supervised technician must install the iL system.
•
Ensure that the installation technician is familiar with the safety procedures which relate to
the products pumped. Wear the appropriate safety-clothing when you come into contact
with contaminated components. Dismantle and clean contaminated components and drain
oil inside a fume-cupboard.
•
If the iL system is to replace an existing pumping system, vent and purge the process system
with nitrogen for 15 minutes before you start installation work; if the existing pumping
system is an iL system, use the procedure in Section 6.1.2.
•
Disconnect the other components in the process system from the electrical supply so that
they cannot be operated accidentally.
•
Do not reuse 'O' rings and do not allow debris to get into the iL system during installation.
•
Consult BOC Edwards publication P300-20-000 (Vacuum Pump and Vacuum System
Safety) before you pump hazardous materials. This publication is available on request:
contact your supplier or BOC Edwards.
3.2 Installation checklist
The operations required to install the iL system and the sections of this instruction manual which
describe those operations are shown in Table 3-1.
iL Dry Pumping Systems 3-1