Blueprint Subsea seatrac X100 Series, Руководство пользователя

Страница: 57 / 140

SeaTrac Serial Command Interface Reference
Page 57
6.4.9. SETTINGS_T (Settings Record Structure)
The Settings Record structure is used to either retrieve the current working settings values in
use from the beacon, or apply new changes to the beacon.
As this structure contains current calibration and communication settings for the beacon, it is
always recommended to read the contents of the structure from the beacon rather than
populating a new structure from scratch.
See Settings manipulation commands in section 7.4 from 83 for further details.
Settings marked with the “

” symbol are only applied on power-up or following a
CID_SYS_REBOOT command.
Parameter Type Description
STATUS_FLAGS UINT8 Value containing flags that control the generation
and output of CID_STATUS messages.
Bit values are…
 Bits[7:3] = RESERVED Reserved for future use, treat as 0’s.
 Bits[2:0] = STATUS_MODE Specifies how often periodic status output
messages are generated. Mask and then treat as a
STATUSMODE_E value.
STATUS_OUTPUT STATUS_BITS_T A bit-mask specifying which information should be
included in generated status output messages.
For each bit set in this mask, a corresponding
group of output fields will be appended to status
messages (making them larger in size).
For details of how these fields affect the status
message content, see
CID_STATUS .
UART_MAIN_BAUD

BAUDRATE_E Specifies the serial baud rate to be used by the
main communications port.
UART_AUX_BAUD

BAUDRATE_E Reserved for future use.
When populating this field, use a default value of
BAUD_115200.
NET_MAC_ADDR

MACADDR_T Reserved for future use.
When populating this structure, use a default value
of 0.
NET_IP_ADDR

IPADDR_T Reserved for future use.
When populating this structure, use a default value
of 0xC0A801FA (192.168.1.250).