Blueprint Subsea seatrac X100 Series, Руководство пользователя

Страница: 67 / 140

SeaTrac Serial Command Interface Reference
Page 67
7.1.3. CID_SYS_REBOOT
The CID_SYS_REBOOT command is sent to perform a software reset of the beacon. To prevent
accidental resets, the command requires an additional UINT16 constant value to be specified
after the CID code.
On receiving a valid reset command, the beacon performs the following actions…
 The status LED turns yellow
 The response message is transmitted
 The serial port is closed, so no further commands can be decoded.
 A 500ms shut-down period is observed.
 The beacon restarts, any communications settings changes made will be applied.
 Human readable power-up diagnostic information is output from the serial port.
 The beacon is ready to receive further commands.
Command Message Parameters
Parameter Type Description
MSG_ID CID_E Command identification code (CID_SYS_REBOOT)
CHECK UINT16 Check constant value used to confirm a reset
should be performed. This value should be 0x6A95.
Response Message Parameters
Parameter Type Description
MSG_ID CID_E Command identification code (CID_SYS_REBOOT)
STATUS CST_E Status code used to indicate if the command
executed successfully.
Valid values are…
 CST_OK – The command was performed
successfully.
 CST_CMD_PARAM_MISSING - The CHECK
parameter was not specified in the
Command Message.
 CST_CMD_PARAM_INVALID - The CHECK
parameter was incorrect in the Command
Message.