BLACKBERRY RADAR R2 ITE100-1 INSTALLATION GUIDE
DRY VAN, INSULATED TRAILERS (BARN DOORS)—CARGO PERCENTAGE
39
5.
Locate the alcohol pad that was included in your adhesive kit. Open the package and
thoroughly clean both substrates where the 3M VHB tape will be applied (back of the
module and the installation surface, defined by the outline traced in Step 3). Wipe dry
with a clean cloth.
6.
Locate the 3M VHB Universal Primer ampule that was included in your adhesive kit. Apply
the primer to the back of the module, where the tape will be applied.
IMPORTANT:
If the module will be installed on a plastic surface, you must apply the
primer to the installation surface. This will improve adhesion on plastic surfaces.
To apply the primer:
A)
Crack the ampule at the “Crush at Dot” icon to release the primer and saturate the felt
applicator tip, at the end of the tube.
B)
Once the primer has saturated the applicator, rub the felt tip where the tape will be
applied to the module. Apply primer to the installation surface.
Dot
