Beckman Coulter Avanti J-25, Инструкция по эксплуатации

Страница: 53 / 81

3-14
Operation
➠
NOTE
If a diagnostic condition causes the run to stop, a
diagnostic message appears and the red [
STOP
]
indicator light flashes until the rotor comes to a
complete stop. See Table 4-1 for diagnostic code
explanations and troubleshooting procedures.
PROGRAMMED OPERATION
The centrifuge internal memory can store up to thirty programs, each
containing up to two steps (each step is a set of run parameters).
Programs are retained in memory when the power is turned off.
CREATING A NEW PROGRAM
Action Result
1. Press [
OPT
]. Default system parameters appear, the Prog (ram) Recall: field
flashes, and the message line says “Enter program number (1–30).”
2. Press [
OPT
] again to move the
cursor to the Setup: field.
Use the keypad to enter a
program number in this field.
A two-step program is created and is assigned the number you
entered. If you enter a number that is already assigned to a program,
you can either overwrite the program or select another program
number.
A message prompts you to enter parameters for step 1.
Rotor : JA-25.50
Speed : 0 RPM = x G
Time : 00:00
Temp : 25°C Max Temp : 29°C Shutdown? No
STEP1
STEP2
SAVE
EXIT
Accel : MAX Decel : MAX
Prog Recall: Setup: 1 Step #1
SPEED
TIME
TEMP
A/D
OPT
ROTOR
Enter parameters for the selected step