Beckman Coulter Avanti J-25, Инструкция по эксплуатации

Страница: 41 / 81

3-2
Operation
SUMMARY OF RUN PROCEDURES
For runs at other than room temperature, precool or prewarm the rotor to the required temperature before
the run.
MANUAL RUN
1 Press the POWER switch to on (I).
2 Depress the foot pedal to open the chamber door.
3 Install the rotor according to instructions in the applicable rotor manual, then firmly
close the chamber door.
4 Press
[
ROTOR
]
, press the soft key to select rotor type, press the soft key to select the
rotor name.
5 Press [
SPEED
] , press the soft key to select RPM or RCF mode, then use the keypad to
enter the run speed (0 to 25 000 rpm).
6 Press
[
TIME
]
, press the soft key to select a time mode (HH:MM, Hold, or
ω
2
t ),
then use the keypad to enter the run time or
ω
2
t value. (No entry is made in Hold
mode.)
7 Press
[
TEMP
]
, then use the keypad to enter the required run temperature.
8 Press [
A/D
] and press the MAX, SLOW, or TIME soft key. Or, skip this step and accept
the default acceleration rate (SLOW for the JS-24.38 and JS-24.15 rotors; MAX for all
other rotors).
9 Press [
A/D
] and press the MAX, SLOW, TIME, or OFF soft key. (Or, skip this step and
accept the default deceleration rate (SLOW for the JS-24.38 and JS-24.15 rotors; MAX
for all other rotors).
10 Check that all parameters are correct and that the door is closed. Press
[
ENTER
]
, then
press [
START
] .
11 Wait for the set time to count down to zero, or end the run by pressing [
STOP
] .
12 When the rotor stops, depress the foot pedal to open the chamber door.