Barcrest MPU6, Руководство по обслуживанию на месте

Страница: 17 / 93

17
If the key code has already been set up and is valid then the display indicates “KEY
KNOWN”.
If the key code is incorrect then the display indicates “BNV NO RESPONSE”.
If no note acceptor is fitted and the key code is 00000 then the display indicates “BNV NOT
FITTED”. (Refer to section 2.11 for button definitions).
2.3.14 - Test 14 Token Enabling Menu
This test is used for enabling or disabling tokens (where used).
To select this test, enter the self-test mode as described in 2.3.2 and step through the tests
using the RH1 button until 14 Token Select is indicated on the alphanumeric display.
To start the test, press the RH2 button to step forward through each token settings and RH5
to step back. The alphanumeric display will then display the following message for each
press of RH2.
•
TOK = RAL 50p.
•
NOT TOKENS.
To enable the token select RH3 and then machine will exit the test. ((Refer to section 2.11
for button definitions).
2.3.15 - Test 16 RTC Clock Setting
To comply with the regulations enforced on the 1
st
of September 2007 it was necessary to
have a real time clock facility. This section details the instructions required to set the real
time clock (RTC).
When the machine is first powered up or has had a program card or PIC change, then it is
necessary to set this up using the function buttons listed below.
•
Select LH2 to step the current selected digit to the left.
•
Select LH3 to step the current selected digit to the right.
•
Select LH4 to Increment the current digit value.
•
Select RH4 to Decrement the current digit value.
•
Select RH2 to set the Time/Date settings and the machine will now reset.
•
Select RH1 to go back to the default Time/Date if required.
When the RTC clock has to be set manually, then enter test 16 using the function buttons
listed above.
(Refer to section 2.11 for button definitions).