Barco IMAGETILE, Системное руководство

Страница: 69 / 135

System manual ImageTile 70
Setting the Resolution of Your ImageTile Display Panel with
DualView Enabled
By default DualView is enabled when you install the BarcoMed
Windows XP driver. DualView is a Windows XP feature that allows a
dual headed imaging board with a single graphics chip to display two
separate desktops, one for each monitor instead of a single virtual
desktop that spans across both monitors. If you wish to disable
DualView, you can do so through the Monitor Configuration settings of
the Barco Metheus Configuration Tab. Instructions for disabling
DualView can be found at the end of this chapter.
1. To set the resolution for your ImageTile display panel(s), right click
on an empty space of the desktop and select “Properties”.
2. Select the “Settings” tab (see figure 49 on the next page). Now
select the rectangle that represents the first ImageTile display
panel attached to the BarcoMed 3MP2FH Imaging Board you are
working with.
SPECIAL NOTE: If the BarcoMed 3MP2FH Imaging Board is not
running VGA, the display may not be enabled yet. To enable the
device check the “Extend my Windows desktop onto this
monitor” checkbox. Do not click the “Apply” button at this time.
3. Click on the “Advanced” Button.
4. Select the “Adapter” tab and then click on the “List All Modes…”
button. Select the resolution and refresh rate that your ImageTile
display supports from the dialog box and click “OK”.
5. Click “OK” on the bottom of the Adapter Control Panel. If the
“OK” button on the bottom of the Adapter Control Panel is not
visible, press the “Tab Key” once and then press “Enter”. Your
high resolution display(s) should now synchronize and display the
Windows desktop.
6. Click “Yes” if asked, “Your desktop has been reconfigured. Do
you want to keep these settings?” Windows XP will only ask this
question for the first display on each BarcoMed 3MP2FH board.
7. To set the resolution of the second ImageTile display panel
attached to the BarcoMed 3MP2FH Imaging Board you are
working with, open the “Display Properties Control Panel” again
by right clicking on the desktop and select “Properties”. Now
select the “Settings” tab. Now repeat step 3 – 6 above.
Repeat steps 1 – 7 to set the resolution for the displays on all the
BarcoMed 3MP2FH Imaging Boards installed in your system.
BarcoMed software driver installation