Barco IMAGETILE, Системное руководство

Страница: 68 / 135

System manual ImageTile 69
15. If the Wizard has successfully installed the drivers for all of the
displays supported by your BarcoMed 3MP2FH imaging board(s),
the Wizard will prompt you to click “Finish” (see figure 46).
Clicking on “Finish” will exit the Wizard and restart your computer
now. Click “Cancel” to exit the Wizard and restart your computer
at a later time. If the installation failed, click “Finish” to exit the
Wizard (see figure 48) and try reinstalling the drivers following the
steps above or following the step outlined in the section
“Reinstalling or Updating your BarcoMed Drivers” found later in this
chapter.
Figure 46
Click “Yes” to confirm reboot when you see Figure 47.
Figure 47
Figure 48
BarcoMed software driver installation