Barco IMAGETILE, Системное руководство

Страница: 52 / 135

System manual ImageTile 53
To set the resolution of the second ImageTile display attached to the
BarcoMed 3MP2FH Imaging Board you are working with, go back to
the “Settings” tab of the “Display Properties Control Panel”. Attach
the display you detached in step 2 above, by right clicking on the
rectangle that represents it and selecting “Attached”.
Now repeat steps 3 – 7 above for this display.
If you are using a Quad-Head Configuration repeat all of the above
steps for the two displays on the second imaging board.
Special note: After installing DualView and setting the resolutions in a
Quad-Head Congifuration you may need to drag the heads into the
proper position in the window on the “Settings” tab, so that the
arrangement in the window on the “Settings” tab matches the
physical arrangement of your configuration.
After installing DualView use the Barco Metheus Configuration Control
Panel to verify or change your system settings.
Figure 29: The Windows 2000 Display Properties Control Panel Settings Tab
after the drivers have been installed and the resolution set with DualView
Enabled.
Note: The system shown in figure 29 above is a dual-head, single
BarcoMed 3MP2FH Imaging Board, no 3
rd
party VGA card
configuration, your system may look different.
BarcoMed software driver installation