Barco IMAGETILE, Системное руководство

Страница: 29 / 135

System manual ImageTile 30
Vid1
Vid2
Vid1
Vid2
CONNECTING THE SIGNALS
To connect the signals:
1 Be sure the imaging board(s) are installed according to the
instructions from the "Imaging board installation" chapter in this
manual.
For a dual-head panel, 1 board must be installed. For a quad-head
panel, 2 boards must be installed.
2 Connect the outputs of the imaging board(s) to the DVI connectors
(4) on the panel.
For each board, the leftmost head must be connected to the Vid1
output (see illustration).
3 If you wish to use the built-in Sentinel reporting functions, connect
the panel to a local network. Plug the network cable into the
panel's network plug (6).
To connect the power:
- Connect the power input (7) to a grounded AC power outlet.
- The display automatically adapts to the voltage. The voltage range
is: 100-240 VAC - 10% / + 6%.
Note:
From the moment you connect the power to the panel, the panel is
under tension. If you press the soft switch (3), the panel is switched in
stand-by. Press once more to switch the panel on again.
ImageTile installation