Barco IMAGETILE, Системное руководство

Страница: 42 / 135

System manual ImageTile 43
Installing the BarcoMed 3MP2FH Windows 2000
Display Driver
Installing the Driver Using the BarcoMed Driver Installation
Wizard
SPECIAL NOTE: Prior to installing the BarcoMed drivers you MUST
install the BarcoMed Imaging Board(s), connect the ImageTile display
panel(s) to the card(s), and turn the ImageTile display on. Refer to
the Hardware Installation section of this manual for instructions on
installing the BarcoMed Imaging Board(s) and connecting them to the
ImageTile display panel(s).
The following driver installation instructions presume that Windows
2000 is already installed on your system. If you need to install or
reinstall Windows 2000 on your system you must first remove the
BarcoMed Imaging Boards and use a 3
rd
party VGA card and VGA
monitor during the Windows 2000 installation process.
To install, reinstall or update your BarcoMed 3MP2FH Windows
Display Driver for the first time follow the steps below. If you are
reinstalling the drivers or installing a new driver release over an
existing driver release skip to the step 5 on the next page:
1. Install the BarcoMed 3MP2FH Imaging Board(s) into your machine.
Please refer to the hardware installation section of this manual for
more information.
2. Boot the machine, and log in using an account with administrator
privileges.
3. For each 3MP2FH board you have installed, Windows 2000 will
automatically launch the “Found New Hardware Wizard” (see
figure 13).
Click “Cancel” to exit the “Found New Hardware Wizard”.
Figure 13
BarcoMed software driver installation