Baker Hughes DigitalFlow XGF868i, Руководство по программированию

Страница: 96 / 100

E.2 Configuration utility setup
The following is an example setup using National
Instruments Configuration Utility v3.1.
Figure 59 below shows the configuration utility with a
flowmeter on the network (Panametrics flow-XGF).
Figure 59: Configuration utility setup Example
NOTE: The following procedures assume that the device
has been placed in the OOS (out-of-service) mode before
executing.
E.3 Selecting the desired
measurements
To set the measurement unit for each AI:
1. Double click on the FLOW transducer block (in the tree
under GEFlow-XGF).
2. Select the others tab and open the drop down list
for the PRIMARY_SELECTOR and SECONDARY_SELECTOR
(refer to Figure 60 on page 86 ).
3. Choose the unit from the list (see Figure 60 on page 86 ).
This unit will correspond to the unit that is available in the AI
block for network connection. The PRIMARY_SELECTOR unit
will correspond to ANALOG_INPUT_1 and the SECONDARY_
SELECTOR will correspond to ANALOG_INPUT_2.
4. After the desired measurements have been selected for
the PRIMARY and SECONDARY SELECTOR, choose the unit
system (UNIT_SELECTOR above the PRIMARY_SELECTOR)
that was programmed in the flowmeter (English or SI), as
shown in Figure 60 below.
Figure 60: Primary selector drop down list
86