Baker Hughes DigitalFlow XGF868i, Руководство по программированию

Страница: 62 / 100

C.2 Programming with PanaView™
You can program the XGF868i with PanaView™, a Panametrics PC-based, non-resident software program that communicates
with the XGF868i via its RS232 serial port.
C.2.1 Preparing for PanaView programming
Before you attempt to communicate with the XGF868i,
be sure you have linked your PC to the XGF868i via an
RS232 interface. For details on wiring the interface, refer
to Wiring the serial port in the Startup guide , and to the
document EIA-RS Serial communications (916-054).
You must also install PanaView, as described in the
PanaView User’s manual (910-211).
C.2.2 Setting up the communications port
Use the steps below to establish PanaView communications
with the XGF868i.
1. Launch PanaView, as discussed in
Chapter 3, Initial
setup , of the PanaView User’s manual .
2. Open the new meter browser window in the file menu
and expand the network tree. Then, highlight the my
computer (name) branch by clicking on it.
3. Pull down the edit menu by clicking on it in the
menu bar.
4. Click on the new menu option to select it, and a submenu
opens with two choices on it (see Figure 32 below).
Figure 32: edit menu
5. Click on the communications port option to select it.
The setup communications screen appears similar to
Figure 33 on page 52 .
Figure 33: Setup communications screen
6. Open the protocol menu (the first of the drop-down
menus) and click on IDM .
7. Open the COM port type menu and click on the
desired type (or on TCP/IP , if the XGF868i is using an
Ethernet connection).
NOTE: If you select TCP/IP, the menu changes, proceed
to the next page.
8. Select any suitable available baud rate. A baud rate
of 19200 is appropriate for almost all applications.
However, if you experience periodic communication
reliability problems, you may wish to consider lowering
the baud rate on your instrument and in PanaView.
IMPORTANT
Be sure all the communications port settings match those
made in setting up the meter’s serial port.
9. Click on [ok] to complete data entry.
52