Arctic Cat S2008ACAAAUSG, Руководство оператора

Страница: 53 / 104

MAINTENANCE 49
2. Shut the engine off; then remove
the oil level stick from the oil res-
ervoir. Wipe the stick clean.
ZJ002A
3. Insert the oil level stick into the
oil reservoir without threading it
in and remove. Read the oil level
shown on the stick. The oil level
should be near the middle of or on
the high end of the NORMAL
range on the stick.
0741-490

NOTE: To attain an accurate oil
level reading, do not thread the
stick into the reservoir.
4. If step 1 was followed and the oil
level is at or below the ADD
mark, add up to 1/2 qt of recom-
mended engine oil.

NOTE: Care must be taken not
to over-fill the reservoir with oil.
5. Repeat steps 3-4 until the oil level
is within the recommended range
on the oil level stick.
CHANGING ENGINE
OIL (660 cc Models)

NOTE: The oil should be
changed when the engine is warm
to allow all oil to drain from the
crankcase.

NOTE: Recycle or properly dis-
pose of the used engine oil.
1. Using a putty knife, remove the
belly pan plug.
2. Place a drain pan beneath the
belly pan plug hole; then remove
the oil drain plug and washer
from the underside of the crank-
case.
3. Remove the oil fill cap from the
top of the engine.
4. After the oil has drained com-
pletely, install the oil drain plug
and washer and tighten to 2.3 kg-
m (16.5 ft-lb).
5. Install a new belly pan plug.
6. Remove the oil filter using Oil
Filter Wrench (p/n 0644-389).
7. Apply a light coat of fresh engine
oil to the gasket of the new oil fil-
ter.
8. Install the new oil filter by turning
the oil filter by hand until the gas-
ket has contacted the oil filter
mounting surface; then tighten the
oil filter 3/4 turn by hand.
9. Pour 2.9 l (3 U.S. qt) of the rec-
ommended engine oil into the oil
fill tube; then check the oil level.
! WARNING
Care must be taken if a hot drain
plug is removed by hand. Burning
could occur.