Arctic Cat S2008ACAAAUSG, Руководство оператора

Страница: 30 / 104

26 GENERAL INFORMATION
Servicing rebuildable shock absorbers
is considered normal maintenance and
is the responsibility of the owner. Take
the snowmobile to an authorized Arc-
tic Cat Snowmobile dealer for this ser-
vice. This service is at the discretion
and expense of the snowmobile owner.
Kits are available to either stiffen or
soften gas shock valving. If changes in
shock valving are desired, see an
authorized Arctic Cat Snowmobile
dealer. This service is at the discretion
and expense of the snowmobile owner.
Each shock absorber should be visibly
checked weekly for fluid leakage,
cracks or breaks in the lower case, or a
bent plunger. If any one of these con-
ditions is detected, replacement is nec-
essary. Take the snowmobile to an
authorized Arctic Cat Snowmobile
dealer for this service. If not under
warranty, this service is at the discre-
tion and expense of the snowmobile
owner.

NOTE: When the snowmobile is
operated in extremely cold
weather (-23° C/-10° F or colder), a
small amount of leakage may be
present. Unless the leakage is
excessive, replacement is not
necessary.
DEEP-LUG TRACK
Some models are equipped with a
deep-lug track which is specially
designed for use in powder snow rid-
ing conditions. When the deep-lug
track is operated in hard-packed snow
conditions, it will run slightly slower
than a standard-lug track and it will
accelerate wear strip wear. To
decrease the amount of wear strip
wear, slower speeds must be main-
tained when operating on hard-packed
trails. Accelerated wear strip wear
caused by operating a deep-lug track
on hard-packed snow conditions is
NOT covered under Arctic Cat Inc.
warranty policy.
STANDARD-LUG
TRACK
Accelerated wear strip wear caused by
operating on hard-packed snow condi-
tions is NOT covered under Arctic Cat
Inc. warranty policy.
TRACK STUDS

NOTE: Stud or hooker plate
installation will void track and tun-
nel warranty.

NOTE: Stud installation can be
performed by the snowmobile
owner if qualified to do so. If the
owner does not feel qualified, take
the snowmobile to an authorized
Arctic Cat Snowmobile dealer for
this service. This service is at the
discretion and expense of the
snowmobile owner.

NOTE: To prevent tunnel dam-
age from the studs, Tunnel Protec-
tor Kit (p/n 4639-771) for F 570/T
570 models or (p/n 4639-338) for
Crossfire models must be
installed.
For proper installation, use the follow-
ing procedure:
1. Using Stud Template (p/n 4639-
443) for 128-in. track models or
(p/n 4639-344) for 136-in. track
models, mark the desired stud
pattern to be used.
2. Using the proper-sized stud hole
drill bit, drill out the stud holes.
3. Push the stud through the hole
from inside the track; then place
the domed support plate and lock
nut on the exposed stud.
4. Using a wrench to secure the stud,
tighten the lock nut on the
exposed stud.