Arctic Cat M 8000, Руководство по обслуживанию

Страница: 147 / 210

146
EL-003A
6. Remove idle speed control (ISC) hoses (A) from the
top of the throttle bodies; then disconnect the ISC
from the main harness (B). Remove the screws (C)
securing the ISC; then remove the ISC.
EL-006A
7. Loosen the four clamps securing the throttle body;
then lift up the throttle body and disconnect the cool-
ant lines. Set the throttle body up and out of the way.
8. Remove the intake boot from the chassis.
9. Remove the cable ties (A) securing the positive cable
to the starter motor; then remove the nut securing the
positive cable.
10. Remove the four cap screws (B) securing the starter
motor to the engine.
CWI-108A
TESTING STARTER MOTOR

NOTE: Before installing the starter motor, perform
test to ensure proper operation using the following
procedure.
1. Attach a black jumper cable to a good ground on the
starter.
2. Attach the opposite end of the black jumper cable to
the negative post of a good 12V battery.
3. Attach the red jumper cable to the positive post of
the battery.
4. Holding the starter firmly down on a work bench,
touch the red jumper cable to the positive cable stud
of the starter.
 NOTE: The starter motor must instantly spin at a
high RPM. On the 6000 the pinion must snap out
against the stopper. If the motor does not spin, remove
the red cable immediately. Check the battery condi-
tion and all connections.
INSTALLING (8000)
1. Secure the starter motor to the starter motor mount-
ing bracket using two cap screws (A) (threads coated
with blue Loctite #243 and one Allen-head screw (B)
(threads coated with blue Loctite #243). Tighten the
Allen-head screw (B) to 25 ft-lb. Tighten the cap
screws (A) to 25 ft-lb.
XM044A
2. Secure the MAG-side of the starter motor to the
retaining plate using the eight cap screws (threads
coated with blue Loctite #243). The washer and neg-
ative battery cable must be installed in the upper
location. Tighten to 96 in.-lb.
SNO-352
! WARNING
Be sure to keep clear of the pinion gear area as it will
spin at a high RPM when the red cable is touched to the
positive stud. Personal injury may result if contact is
made with a spinning pinion.