Arctic Cat M 8000, Руководство по обслуживанию

Страница: 166 / 210

165
Cleaning And Inspecting
1. Using a parts-cleaning solvent, wash grease, dirt, and
foreign matter off all components; dry with com-
pressed air.
2. Remove any drive belt dust accumulation from the
stationary sheave, movable sheave, and bushings
using parts-cleaning solvent only.
3. Inspect the roller assembly for wear or damage.
 NOTE: Flat spots or diameter cannot be less than 23
mm (0.925 in.).
4. Inspect shaft for nicks or burrs.
5. Using a spring compression scale, measure spring
rate at proper load heights (secondary springs mea-
sured at load heights of 2.2 in. and 1.1 in.).

NOTE: If a spring rate measures less than 10% of
specified load height, it must be replaced.
6. Measure the inside diameter of the movable sheave
bushing. Bushing to shaft clearance must not exceed
0.25 mm (0.010 in.).

NOTE: If clearance exceeds the limit, the bushing
must be replaced.
Assembling
1. Install the spacer and the movable sheave onto the
driven clutch shaft.
2. Place the retaining ring and spring into the driven
clutch; then place the roller assembly and snap ring
over the spring.
FS031
3. Position the roller assembly so the “X” mark is
directly in line with the keyway on the driven clutch
shaft.
FS033A
4. With Driven Clutch Compressor Tool, compress the
roller assembly enough to allow the snap ring to be
properly secured to the shaft.
CM090

NOTE: While compressing the roller assembly, it
may be necessary to work the spider assembly back
and forth to properly mate the splines.
5. With the “X” mark on the movable sheave lined up
with the “X” mark on the roller assembly, place the
cam with the desired angle into position; then secure
the cam to the movable sheave with the four torx
head cap screws. Tighten to 5-6 ft-lb.
CM091B
CAUTION
Do not use steel wool or a wire brush to clean compo-
nents having a bushing; damage to the bushing will
result.