Antec Scientific ROXY Exceed, Руководство пользователя, Страница: 46 / 126

46 211_0010 - ROXY Exceed user manual - rev 04
Parameter Screen Description Type
means that the cell potential runs
from E1 to E2 and back to E1
continuously (/\/\/\/\
……..). Press-
ing “STOP” or finishing the cycle,
sets the potential to E1.
DIAG main Enters Diag screen F
DISPL test Enters DISP screen for display
test. F
E1, E2, E3,
E4, E5
pulse setup2
pulse setup3
Controls the cell potential settings
of the pulse. Can be set between
+2.50 and
–2.50 V with 10 mV
steps. Can only be set or changed
after confirmation with the ‘enter’
button.
C
Ec dc setup Controls the cell potential, can be
set b2.50 and
–2.50 V
with 10 mV steps. Can only be set
or changed after confirmation with
the ‘enter’ button.
C
Ec run (dc only),
scan stat (dur-
ing scanning) Reflects the set cell potential. Dis-
plays the actual cell potential in
the scan mode. S
Filt
(DC mode) dc setup, dc
stat Filter settings: RAW (100 Hz), Off
(10 Hz) and 1 Hz to 0.001 Hz cut
off frequency, in 1, 2, 5 steps. C
Filt
(PULSE
mode) pulse setup,
pulse stat Filter settings: Off and 0.5 Hz to
0.001 Hz cut off frequency, in 1, 2,
5 steps. (Fcut-off / filter coeffi-
cients based on 1 Hz input fre-
quency in pulse mode ) C
Filt run Reflects the actual filter setting. S
Firmware system Displays firmware version S
Hold
resume run, scan stat Toggle, holds or resumes execu-
tion of scan.
F
HOLD=0,1 run, scan stat Holds or continues execution of
scan. Toggles between 1 and 0.
Pressing hold again continues
scan were it has been hold.
F
Ic stat (dc,
pulse, scan), ,
run, noise Displays the true, non-compen-
sated cell current, unaffected by
auto zero or offset. S