Antec Scientific ROXY Exceed, Руководство пользователя, Страница: 45 / 126

Chapter 4 ROXY Exceed control 45
Parameters
Explanation: Type S is status, F is function and C is control.
Parameter Screen Description Type
28 > 30
˚
C dc stat
pulse stat
scan stat
run Displays the actual (left value)
and the pre-set oven temperature
(right value). S
AZERO dc stat, run,
pulse stat,
scan stat
Sets the output voltage to 0 V, or
to the offset voltage. Control
Comp = off changes to Comp =
on. If cell current exceeds the
max. compensation a message
“cell current exceeds max. com-
pensation” appears. In that case
max. compensation will be ap-
plied, which may not be the 0 Volt
level but higher.
F
Boot system Displays boot firmware version S
CELL=ON/
OFF dc stat, pulse
stat, scan
setup, scan
stat
Toggles between cell ‘ON’ and
‘OFF’. Confirmation is required
“Switch cell on (off)?” Switching
on resets the clock to 0.00. Pulse
mode: pulsation occurs as long as
the cell is on, irrespective which
screen is selected. Scan mode:
potential E1 is applied.
F
Checksum system Displays checksum S
Comp dc stat, pulse
stat
Toggles between ‘ON’ and ‘OFF’,
releases auto zero offset.
Switches ON if AZERO is
pressed. Affects auto zero com-
pensation only, not the % offset!
C
CONFIG main Enters config screen F
Contrast config Sets the contrast of display C
Cyc scan setup Controls the nature of the cycle:
half, full and continuous. ‘Half’
means that the cell potential runs
from E1 to E2 and stops at E2 (/|
). ‘Full’ means that the cell poten-
tial runs from E1 to E2, and back
to E1, and then stops (/\
). ‘Cont’
C