Antec Scientific ROXY Exceed, Руководство пользователя, Страница: 26 / 126

26 211_0010 - ROXY Exceed user manual - rev 04
Mains connection
Check that fuses and voltage range on the rear side of the instrument
match that for the power outlet to be used.
This device complies with the requirements of EN 55011 group 1 class
A ISM equipment. In a domestic environment this product may cause
radio interference in which case the user may be required to take
adequate measures on his own expenses. Understanding power
surges. Power surges, line spikes, and transient energy sources can
impede instrument operation. Ensure that the instrument's electrical
supply is adequately protected from these conditions and properly
grounded. If necessary connect the instrument to a filtered mains inlet.
Power supply and protective earth: The system must be connected to a
suitable mains power supply with a correctly installed protective earth
conductor. Never use the system without a properly connected
protective earth conductor.
Leave the instrument powered off until specifically mentioned in the proce-
dure below.
PC connection
Follow the instructions in this paragraph when the instrument is used with
PC control over LAN using the Dialogue Elite software. This section can be
skipped if the instrument is used stand-alone (manual control using key-
board/display) .To be able to communicate over LAN a computer is re-
quired with a free (PCI, PCI Express or PCI-X) LAN port.
The ROXY Exceed has a fixed IP address: 192.168.5.1, with subnet mask:
255.255.255.0. Gateway and DNS are not filled in.
The instrument is standard delivered with a special crossover LAN (UTP)
cable (pn 250.0170) which is part of the ROXY Exceed accessory kit (pn
211.0200).