Ampac FireFinder PLUS, Установка, пусконаладка и эксплуатация

Страница: 33 / 128

Page 26
- Active at access level 2 and 3
This control is used to disable (and enable) the Alarm Devices.
If the indicator is
“ON” Steady when any Alarm Devices (including Outputs configured as Alarm
Devices) are disabled and flashes if Alarm devices are in fault. Disable has priority over fault.
- Active at access level 2 and 3
This control is used to disable (and enable) all the ancillary outputs.
The indicator is “ON” Steady when Ancillary outputs are disabled and flashes if Ancillary Outputs have
faults present.
- Active at access 2 and 3
– only when the indicator is flashing.
When the indicator is lit the control is used to override any pre-configured delays to outputs.
The indicator is “ON” Steady when a Delay is programmed and flashes when a Delay Timer is running.
- Active at access level 2 and 3
This control is used to disable (and enable) the external alarm devices output.
If the indicator is “ON” Steady when any Ext Alarm Device output is disabled and flashes if Ext Alarm
device outputs are in fault. Disable has priority over fault.
- Active at access level 2 and 3
The selection keys are used to select a loop device (or range of devices by using
the TO key) or select a zone (or range of zones).
Once a device or zone (or range) has been selected, the DISPLAY or DEVICE
DISABLE/ENABLE controls can be used.
Press this button followed by a number to select the loop you wish to access. e.g.
LOOP 4.