DAVINO 120TW - USER AND MAINTENANCE MANUAL Rev.04
- Pag. 89
CHECKING AND REPLENISHING BRAKE OIL LEVEL
The
brake fluid reservoir is located inside of the rotating turret column under the Operator’s seat. Check that the
level is sufficient at start-up.
For replenishing, use only the liquid indicated
in the TABLE OF LIQUIDS. Usage of non-
approved liquids will damage the braking
system.
Always check that ALL braking elements work
properly.
In the event of malfunctions and failures contact or visit your nearest
AMOG AUTHORIZED SERVICE CENTER. Should you drain oil from the
braking system, follow the instructions under this manual carefully.
CLEANING THE ENGINE AIR FILTER CARTRIDGE
(see also Engine Manual)
If the air filter clogs, the air can split the material of air filter element. Unfiltered air will drastically accelerate the
use of components inside the motor.
Therefore, check daily that there is no accumulation of dust or debris inside the filter and remove the dirt when
needed. Also, check that there are no tears or holes in the filter elements, and the filter gasket is not damaged.
Operating conditions (dust, dirt, and debris) may require service of the air filter element more frequent.
In any case, replace the air filter element at least once a year, regardless of the number of times the element
has been cleaned
Always use safety glasses with side shields when working with
compressed air.
Limit the pressure to 2 bar according to current regulations
To execute air filter maintenance, follow indications below:
Set machine on level ground
Remove the cap
A
Remove the cartridge
B
Clean the cartridge
B
with compressed air at 2 bar until to eliminate the
accumulated dust.
Always begin cleaning the inside to force dirt particles toward the dirty side
(outside).
Aim the compressed air pipe so that air flows into the filter element
lengthwise sense to the filter to prevent paper pleats from being damaged. Do not point the airflow straight
against the primary element to avoid more dirt in pleats.
The compressed air does not remove deposits of carbon and oil.