© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
5
802953
Preliminary Information
About the Control
This control is an advanced, programmable computer
that lets the owner control most machine features by
pressing a sequence of keypads. Refer to
Figure 1
.
The control allows the owner to program custom
cycles, set vend prices, retrieve audit information, run
diagnostic tests, program special vend features and set
other programmable features. Refer to
Programming
Control
for a list of features. Washers shipped from
the factory have a default cycle setting of PERM
PRESS 60 built in. However, the owner can change
the default cycle, or any cycle, as needs permit.
IMPORTANT: In the event of a power failure, the
control will not have to be reprogrammed. It is
designed with a memory system that will remember
how it was programmed until the electrical power
is restored.
IMPORTANT: It is extremely important that the
washer has a good ground connection and that all
mechanical and electrical connections to the control
are made before applying power to or operating the
washer.
Glossary of Terms
The following are a few terms and abbreviations to
learn. These are referred to throughout the instructions.
Display - This term refers to the window area of the
control that displays words and values.
LED (Light Emitting Diode) - This term refers to the
lights next to the keypads and status words of
the control.
Power Failure Recovery
If a cycle is in progress and the power fails, the cycle
status is saved in memory. When the power recovers,
the washer will resume into the previously active cycle
if so programmed by the owner.
The owner may program a special feature called
POWER FAIL RESET which sets a maximum power
failure duration. To program this feature, refer to
Programming Control, option 30
.
If the length of the power failure is greater than the
POWER FAIL RESET time, the control will end the
cycle and the display will revert back to the ready
mode. On drain pump models, if the wash basket is
full of water, the control will move to a Delicate final
high speed spin and prompt the user to press the
START (enter) pad. Once the START (enter) pad is
pressed, the control will spin out the cycle.
Communications
The control may be programmed manually, by infra-
red communication with an external device or by the
network. A limited number of features can be
programmed by a card reader.
Infra-red Communications (Optional)
An external device, such as a PDA, allows the owner
to program and retrieve information from the control
without touching the keypad. An external device
greatly expands the programming options available to
the owner. However, it is not required to program and
operate the washer. The operation of an external
device and the advanced features available are covered
separately in the instructions included with the
external device software. Contact Alliance Laundry
Systems for a list of approved PDAs and other external
devices.
Serial Card Reader Communications (Card
Models Only)
The control will accept communication with a serial
card reader in order to perform vending transactions
when a card is inserted to pay for cycles. The card
reader can also allow the owner to program a limited
number of features and collect audit information.
For detailed information on the serial card reader
communications, refer to instructions included with
the card reader.
Network Communications
The control will also accept communication with a
network interface board which allows the control to be
linked to a personal computer. This network link
allows an owner to program, collect data, and run
diagnostics on any machine.
For detailed information on network communications,
refer to the network instructions.
Содержание ST3LXFSP401NW22
Страница 2: ......
