iLive Reference Guide – Firmware
Part 2 - 42
AP6526-2 iss.4
Output Sources
The user assigned name is displayed below the channel
number. If a channel is not available a red cross appears.
Note:
If sockets have been assigned as INSERT Sends then they are not
available to be assigned using the
OUTPUTS
page
. To re-use the socket,
first unassign it using the INSERT screen associated with that input or mix.
Choose the Source from:
Not Patched
The socket is unassigned. No signal present.
Mono or Stereo Group
Post processing, post fader Group mix
output.
Mono or Stereo Aux
Post processing, post fader Aux mix
output.
Main
Post processing, post fader Main mix output. The channel
number ranges from 1 to 4 and depends on the main mix currently
configured, for example LCRSub type 1=L, 2=R, 3=C, 4=Sub.
Mono or Stereo Matrix
Post processing, post fader Matrix mix
output.
Input Direct Output
From the assigned channel number. The
direct output source is globally set in the
MIXRACK / Mixer Pref /
Direct Output
page. You can choose the point in the signal path and
whether it follows the channel MUTE and FADER functions. It is
common to assign channel direct outputs to multitrack inputs when
recording a live show typically set Post Preamp.
MixRack inputs
This routes the output of the MixRack input
preamps directly to the output sockets. The signal is sourced just
after the ADC converter and before the channel processing. For
example, use these sources to provide a digital mic splitter via Port B
for FOH/Monitor mixing, or to record directly off the mic preamps.
Bus Outs
Assign the pre fader, pre processing mix signals to the
sockets. For example, use these sources when linking two systems
together to expand the number of inputs feeding the mix.
Port A / B sources
Assign signals directly from the Port A or B
digital audio network options to the sockets. For example, route the
Main mix from the FOH system to sockets on the Monitor System
Rack over a Port B split.
PAFL L/R
Output from the system stereo PAFL monitor. Assign to
a pair of MixRack sockets to connect to the Surface headphones/local
monitor system using analogue cables when an iLive system does
not have the Port A option fitted. The rear of the iLive Surface
provides analogue monitor input sockets for this purpose. These are
not available on the T Series.
Mono or Stereo Wedge / IEM
Routes PAFL monitor signals
controlled by Wedge or IEM master strips to the sockets. Used for
the monitor application.
