Agilent Technologies 4294A, Руководство по программированию

Страница: 432 / 518

432 Chapter 16
GPIB Command Reference
SEARMINP
SEARMINP
Syntax SEARMINP <numeric>
SEARMINP?
Description For the marker search function for the active trace (set with the “TRAC” command on page
457), if the partial search is enabled (specified to ON with the “PARS” command on page
395), sets the partial search range lower border value to the specified measurement point.
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response
{numeric}<newline><^END>
Corresponding
key
No front panel key is available to execute this function.
SEARNG
Syntax
SEARNG {FULL|SEGMENT}
SEARNG?
Description
For the active trace (set with the “TRAC” command on page 457), sets the search range for
the list sweep: all segments (entire sweep range) or a single segment. To specify a segment
when the search range is set to a single segment, use the “SEGMNUM” command on page
436.
Parameters
Query response {FULL|SEGMENT}<newline><^END>
Corresponding
key
[Search]
-
SEARCH RANGE MENU
- {
FULL
|
SEGMENT
}
<numeric>
Description Number of the measurement point you want to set to the lower
border value (the number assigned in order from the left edge
assuming that the number of the leftmost measurement point is 1)
Range 1 to the number of points
Initial value 1
Resolution 1
Description
FULL (initial value) Specifies all segments as the search range.
SEGMENT Specifies a single segment as the search range.