Agilent Technologies 4294A, Руководство по программированию

Страница: 404 / 518

404 Chapter 16
GPIB Command Reference
POWMOD
POWMOD
Syntax POWMOD {VOLT|CURR}
POWMOD?
Description Selects voltage or current to set the oscillator (OSC) power level. To set the oscillator
power level setting method of each segment when creating the list sweep table, use this
command.
Parameters
Note that, if you use this command to create a segment, the initial value when creating
segment 1 is the current setting method selection value and the initial value when creating
an additional segment is the setting method selection value of the previous segment.
Query response
{VOLT|CURR}<newline><^END>
Corresponding
key
[Source] - OSC UNIT [ ]
PREP
Syntax
PREP
Description
When the measurement results are listed as a result of the execution of the “LISV”
command on page 341, displays the previous page of the list. To display the next page,
execute the “NEXP” command on page 363.(No query)
Corresponding
key
[Copy] - SELECT CONTENTS - LIST VALUE - PREV PAGE
PRES
Syntax
PRES
Description
Resets to the preset state. The preset state is almost the same as that of the reset using the
“*RST” command on page 260, though there are some differences shown bellow. (No
query)
• The sweep mode is set to CONT.
• The HP Instrument BASIC is not reset.
Corresponding
key
[Preset]
Description
VOLT (initial value) Specifies the voltage setting.
CURR Specifies the current setting.