Agilent Technologies 4294A, Руководство по программированию

Страница: 397 / 518

Chapter 16 397
GPIB Command Reference
PDELT
16. GPI
B
Com
m
an
d Re
fe
re
nce
( O -
R )
PDELT
Syntax PDELT <numeric>[S]
PDELT?
Description Sets the delay time for each measurement point.
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric}<newline><^END>
Corresponding
key
[Sweep]
-
TIME
-
POINT DELAY
PEAK?
Syntax PEAK?
Description Within the waveform analysis range set with the “ANARANG” command on page 267,
searches for the maximum peak and reads out the measurement parameter value and the
sweep parameter value of the peak. If there are several maximum peaks, reads out the value
of the leftmost peak within the analysis range. If no peak exists, 0 is read out.
The peak searched for at the execution of this command satisfies the condition set with the
“THRR” command on page 452. It is not related to the peak definition in the marker search
function. (Query only)
Query response {numeric 1},{numeric 2}<newline><^END>
Readouts are as follows:
{numeric 1}: Measurement parameter value of the maximum peak.
{numeric 2}: Sweep parameter value of the maximum peak.
Corresponding
key No front panel key is available to execute this function.
<numeric>
Description Delay time for each measurement point
Range 0 to 30
Initial value 0
Unit s (second)
Resolution 0.001