–
18
–
Zn ZT P RC In L
010 03 1 10 RF -
Enter all zone information except for Loop number, or press “C” to copy the zone information
on this screen from last saved zone (including Loop).
ZT = Zone Type
P = Partition
RC = Report Code
In = Input Device Type
L = Loop number to which the sensor is connected.
NOTE: Pressing the [C] copies the zone information from the last saved zone, which
includes the input type. Verify this information is correct for this zone.
On this screen,
•
Use the [A] key to move to the right
•
Use the [B] key to move to left and to back up to “ZT” field
Press [
✱
] to accept the existing or newly-entered zone information
ZN B M V A C E AD
010 2 1 1 0 1 1 01
Enter the remainder of the zone’s information, or press the [C] key to copy the zone attributes
on this screen from the last saved zone.
B = Bell/Relay Assignment
M = Maintenance? (only used if “In” = 3 or 6)
V = V-plex Relay? (only used if “In” = 6)
AC = Access Point (only used if ZT = 27, 29 or In = 6, 11, 12, 13)
E = Entry or Exit? (only used if ZT = 27)
AD = Address (only used if “In” = 9 or 10)
If “In” = 9, enter the Device Address
If “In” = 10, enter the PassPoint Zone Number)
NOTE: Pressing the [C] copies the zone attributes from the last saved zone. Verify the
attributes for this zone are correct.
NOTE: When response type 29 is selected, the access point (AC) must be from 01-15.
When the input type selected is 06, the access point selected must be 00.
On this screen,
•
Use the [A] key to move to the right
•
Use the [B] key to move to left and to back up to “B” field
Press [
✱
] to accept existing information
010 INPUT S/N: L
A XXX-XXXX -
If you entered RF, BR, UR or SL for the Input Type, this screen displays. Otherwise the
summary screen for the next zone displays.
Enter the 7-digit serial number, using one of the following methods:
a. Transmit two open and close (or close and open) sequences. For a button-type transmitter,
press and release the button, wait approximately 4 seconds, then press and release the
button a second time.
OR
b. Manually enter the 7-digit serial number printed on a label on the transmitter, using the
Alpha keypad. Then press the [
✱
] key, the cursor will move to the “L” position. You can edit
the loop number, if necessary. When the loop number is acceptable, press [
✱
].
OR
c. Press key [C] to copy the last serial number enrolled (used when programming a transmitter
with several input loops).
Remember, you can use the [A] key to move to the right or the [B] key to move to the left and
to back up to the previous screen.
You can also use the [#] key to back up without saving.
010 INPUT S/N:
L
A022-4064
1
Press [
✱
] to accept the serial number and advance to the “L” position (if method “a” or “c” was
used), then enter the loop number.
If necessary, press the [#] key to back up without saving, and re-enter or edit the serial number
before pressing [
✱
] to save
The system checks for a duplicate. If a duplicate exists, a long error beep and display the
serial number along with a “?” for the loop number, allowing you to re-enter the correct loop
number..
www.PDF-Zoo.com
