–
17
–
Entd
A022-4063 1
Rcvd
A022-4064
If the serial number transmitted does not match the serial number entered, a display
similar to the one at the left will appear. If the loop number does not match, it will also be
displayed.
If so, activate the loop input or button on the transmitter once again. If a match is not obtained
(i.e., summary display does not appear), press the [#] key twice and then enter or transmit the
correct serial number.
010 ZT
P
RC In L
01
2
00
RF
1s
If the serial number transmitted does match the serial number entered, the system will beep 3
times and a summary display will appear, showing that zone’s programming. Note that an “s”
indicates that a transmitter’s serial number has been enrolled.
Press [
✱
] to accept the zone information.
ENTER ZONE NO.
000 = QUIT
011
The system will now return you to the “ENTER ZONE No.” prompt for the next zone.
When all zones have been programmed, enter “000” to quit.
After you have enrolled each wireless device, remove ONE of the serial number labels from that device and affix it in
the appropriate column on the worksheets provided in the
Programming Guide; then enter the other information
(zone number, zone type, etc.) relevant to that device.
When you have finished programming all zones, test each using the system's Test Mode. Do not use the
Transmitter ID Sniffer Mode for this. The system will check only for transmission of one zone on a
particular transmitter, NOT the zones assigned to each additional loop, and also will not verify polling loop
type zones.
Expert Mode Zone Programming
Expert Mode allows you to program zones using the minimum number of screens and keystrokes.
Enter the Programming Mode with [Installer Code] + 8 0 0
Before programming your zones, do the following:
1. Program field 2
✱
00: Number of Partitions.
2. Enable your RF Receiver in Device Programming menu mode.
To program your zones, press
✱
93 to display the "ZONE PROG?" prompt. Enter “0” (N0) to each prompt until the “EXPERT
MODE?” prompt appears.
EXPERT MODE?
1 = YES 0 = NO
Press 1 to enter Expert mode.
SET TO CONFIRM?
0 = NO 1 = YES 0
This prompt will appear once upon entering Expert Mode.
If “Yes,” Confirmation prompts will be displayed after the device’s Serial and Loop numbers
have been entered later.
Zn ZT P RC In L
001 03 1 10 HW -
A summary display will appear, showing zone 1’s current programming or default values.
Zn ZT P RC In L
010 03 1 10 RF 1s
Enter the desired 3-digit zone number and press [
✱
].
Note: If you want to exit the expert mode, enter “000” + [
✱
].
If an “s” appears after the loop number, it indicates that the transmitter’s serial number has
been enrolled.
Use the [D] key to enter and duplicate wireless keys (see “Entering Wireless Keys” later)
www.PDF-Zoo.com
