ADB EURODIM TWIN TECH, Руководство по установке

Страница: 164 / 166

EURODIM TWIN TECH
www.adblighting.com User Manual - Page 62
Issue 1.1
40.1 Procedure to be followed in the Event of an Error
Errors list
Action
Downgraded mode
r, s, t phase error

Verify the external network

Verify the connections on the
cabinet

Verify the main breaker in
the cabinet

Verify the CTRL fuses
The modules connected
on the faulty phase are
no longer useable.
Fan 1, 2, 3 error

Proceed with replacing the
cabinet‟s faulty fan
Risk of an increase in the
temperature inside the
cabinet. See temperature
error.
Controller error

Switch the cabinet off/on at
the mains to remove the
error, where applicable

Switch to the controller (if
present) using the cabinet
selector

Stop the cabinet and
proceed with replacing the
controller
Communication error

Verify the connections
between the TTD HUMAN
INTERFACE (HMI) and the
cabinet
TTD HUMAN
INTERFACE (HMI) will
no
longer be
synchronised with this
controller
24 V, 9 V, 9 V control and
1V2 error

Switch to the controller (if
present) using the cabinet
selector

Stop the cabinet and
proceed with replacing the
controller
Temperature error

Refresh the room
temperature
(See chapter cabinet fan)
Automatic reduction of
the circuit control value
until the temperature is
acceptable
Frequency error

Verify the mains frequency at
the cabinet‟s input

Verify the operating
frequency selected in the
software (ADB service menu)
Poor circuit control
(outputs flash)
Software version error

Change the faulty CTRL or
reload the software from the
TTD HUMAN INTERFACE
(HMI) (ADB service menu)
* The maximum ambient temperatures are defined in the EURODIM Twin Tech data sheet.