ADB EURODIM TWIN TECH, Руководство по установке

Страница: 153 / 166

EURODIM TWIN TECH
www.adblighting.com User Manual - Page 51
Issue 1.1
Information displayed for each circuit, according to the module type:
Thyristor (per circuit)
Sinewave: always " N/A "
Thyristor with Diag:
1 - Displays " OK " if everything is fine
2 - Displays " Damaged ": if a voltage > 210 V is measured whereas the
control measured by the module is < 25 %
Breaker (per circuit) Sinewave:
1 - Displays " N/A " if the control value is < 17 % or the circuit is
overloaded or short-circuited
2 - Displays " OK " if the control value is > 17 % and not overloaded or
short-circuited
3 - Displays " triggered " if the control value is control > 17 % and no
output voltage is measured on the circuit
Thyristor (per circuit):
1 - Displays " OK " if the breaker is engaged
2 - Displays " disengaged " if the breaker has blown
Load (per circuit) Sinewave & Thyristor with diag:
1 - Displays " N/A ":

The control is set to zero

and/or the output voltage is too low
2 - Displays " NO ":

If the control value is > 0

The output voltage is measured

and the current is not measured
3 - Displays " YES "

If the control is present

And the output voltage and the output current is measured
Overloads
(per circuit) Sinewave:
1 - Displays " light ": if the voltage is > 13 A for 30 secs
2 - Displays " medium ": if the current is > 16 A for 10 secs

Here, the control decreases every 500 ms until the current
reaches < 13 A
3 - Displays " Severe ": if the current is > 20 A for 1 sec

The control is automatically set to zero

After 2 mins, an actual control test is repeated and if the overload
is "severe" again, a second test is conducted. If the overload is
still
severe , a status message is displayed at the bottom of the
screen, requesting the user to set all the DMX/ARTNET inputs of
the circuit to zero for 30 secs.
Thyristor with diag.:
1 -
Displays “
N/A
” if the breaker has blown
2 - Displays " YES
” if the breaker is OK and:

If the load is > 3.5KW (for a 3kW module)

if the load > 5.5.5KW (for a 5kW module)

if the load is > 11KW (for a 10kW module)
3 - Displays " NO " in all other cases