ADB EURODIM TWIN TECH, Руководство по установке

Страница: 117 / 166

EURODIM TWIN TECH
www.adblighting.com User Manual - Page 15
Issue 1.1

Hardware/communication:

"OK" if the controller is operating correctly,

"Not OK" if a problem is detected. In this case, an error message and an exclamation
mark appear in the EURODIM TT INFO zone.

Software version: software version present in the controller

Temperature:

"OK" if the temperature measured in the controller is acceptable,

"Not OK" if the temperature measured in the controller is too much high. In this case,
the control value of all of the active circuits is reduced by 1% every minute until the
temperature measured becomes again acceptable* (also see paragraph on the
operation of the ventilation within the cabinet).
12.2 EURODIM Twin Tech Information
The first row of information available informs the user via a message that the cabinet and the
modules are in operation.
The message: "reference modules are used for dimming" indicates that all the modules installed in
the cabinet are identified by the software and enable the cabinet to operate normally.
An error message may be displayed instead.
In this case, press the exclamation mark to display a screen page, "Error list".

R, S, T phase: "OK" or "Not OK", checking the presence of the mains phases at the
controller,

Fan 1, 2, 3: "OK" or "not OK", checking the rotation of each fan arranged in the top of the
cabinet and ensuring air extraction,

Software version: software version present in the Human-Machine interface (TTD HUMAN
INTERFACE (HMI)) Unit.
When any problem is detected by the cabinet. An exclamation mark then appears to the right of the
screen page. In this case, press the exclamation mark to display a screen page, "Error list".
12.3 DMX Information

DMX A/B start address DMX A, DMX B channel value to address cabinet output 1

"x": 1 ≤ x ≤ 512

"not used": channel value = 0 or > 512

"- - - - -": no circuit physically present in cabinet location 1, or circuit identification error
in cabinet location 1 or operating fault.

DMX A/B present: Yes;

Yes: DMX signal reception detected

No: DMX signal reception missing.

Patch A/B (see "PATCH" menu):

Yes: the addressing filled-in in each patch at the circuits is not in ascending order,

No: the addressing filled-in in each patch at the circuits is in ascending order,
e.g. 1, 2, 3, 4, ..., 128 where 32 modules of four circuits are present in the cabinet.
* The maximum ambient temperatures are defined in EURODIM Twin Tech data sheet.