AccuWeb MICRO 4000 NET, Инструкция по эксплуатации

Страница: 20 / 155

Introduction
The MICRO 4000 NET controller’s main functions include polling the web sensors, end-of-travel
sensors, and control inputs, processing the input data, and sending the results to the servo-
amplifier and status outputs.
The controller’s main features include the following:
•
Compatible with all ultrasonic and infrared PointSource and WideArray edge detectors,
ultrasonic Hi-Temp edge detectors, and AccuBeam 3 digital line guide. These sensors are
described on pages 55 and 60.
•
Has a built-in parameter-entry keypad and display.
•
Has a variety of digital inputs and outputs that allow the customer’s PLC to control its
operating modes and monitor its status. These are described on pages 45, 46, and 48. In
addition, the controller can be connected to a wide variety of fieldbus networks by installing
an optional Fieldbus Interface card. This card is described on page 102.
•
Has several analog inputs and outputs that may be used for interfacing to voltage-output
sensors, PLCs and other MICRO 4000 NET controllers. A setup procedure for these ports is
described on page 50.
88 and 97.
•
Compatible with the Remote Stations described on pages
Parameters
The MICRO 4000 NET system is configured by setting programmable parameters. These
parameters are stored in non-volatile memory and may be examined or changed by using the
parameter-entry keypad and display located on the MICRO 4000 NET board.
Note that the CODE and DATA display will show dashes immediately after power is turned on
and after the EXIT button is pressed. The dashes indicate that no parameter is currently selected
for examination or adjustment, but that the system is operating normally.
- - - - - - -
CODE DATA
The general procedure for reading and/or changing the parameters is as follows:
1) Press the UP (
▲
) or DOWN (
▼
) CODE buttons to select the parameter you want to examine
and/or adjust. Each parameter has a unique code number.
2) Press the UP (
▲
) or DOWN (
▼
) DATA buttons to adjust the parameter’s setting.
3) Press ENTER to store the new data value in non-volatile memory. To leave the data value at
its original value press EXIT, or press the UP (
▲
) or DOWN (
▼
) CODE buttons.
The parameters are described below:
Software Version
1 x x. x x This parameter displays the software version.
MICRO 4000
®
NET Controller
17
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com