ABB UMC100.3, Руководство пользователя

Страница: 121 / 160

Diagnosis Data
Word Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit1 Bit 0
0
0
Checkback
missing PTC wiring
failure PTC hot Pre-waring
thermal model Locked rotor
during start-up
(stall)
Phase
imbalance
1
Phase loss
1
Thermal
overload trip
1
Actuator
problem
1
UMC self-test
error Earth fault pre-
warning Eart fault trip
(internal or
externally
triggered)
I above high
current
warning
threshold I above high
current trip
threshold I below low
current
warning
threshold I below low
current trip
threshold
1
2
Trip/Warning
from AuxFault
function block
input 5
2)
Trip/Warning
from AuxFault
function block
input 4
2)
Trip/Warning
from AuxFault
function block
input 3
2)
Trip/Warning
from AuxFault
function block
input 2
2)
Trip/Warning
from AuxFault
function block
input 1
2)
HW fault on IO
module Custom
application
error IO module
missing
3
Warning
triggered from
AM2
Trip triggered
from AM2
Warning
triggered from
AM1
Trip triggered
from AM1
Trip triggered
from
Multifunction
input DI2
Trip triggered
from
Multifunction
input DI1
Trip triggered
from
Multifunction
input DI0
Trip / Warning
from AuxFault
function block
input 6
2)
2
4
- - THD Warning Voltage out of
spec
1
Overload
power Underload
power
1
- Warning LCD
panel missing
5
- - Cooling Time
Running Just one start
left Num Starts
Overrun - - -
3
6
Extended
diagnosis is
available
1) .
Parameter out
of range - - - - - -
7 Fault code. See section "Error Handling, Maintenance and Service-> Fault Messages" for a description of the code.
1) There is more than one root cause that triggers this diagnosis. For details see diagnosis byte seven
2) By default these diagnosis bits are triggered from the digital inputs of the DX111/DX122 IO module. If you have
created an own custom application these diagnosis bits might be triggered for other reasons (see handbook
"Custom Application Editor" for more details).
For more information about integrating the UMC in a PROFIBUS network please refer to the PDP32.0 manual
For more information about integrating the UMC in a PROFINET IO network please refer to the PNQ22-FBP.0 manual
For more information about integrating the UMC in a Modbus network please refer to the MRP31.0 manual (Modbus communication interface)
For more information about integrating the UMC in a ModbusTCP network please refer to the MTQ22-FBP.0 manual
For more information about integrating the UMC in an EtherNet/IP network please refer to the EIU32.0 manual
121 PA R A M E T ER S A N D DATA S T R U C T U R E S O N A FI EL D B US