ABB Relion 670 Series RES670, Техническое руководство

Страница: 839 / 888

en05000132_ansi.vsd
51 51
A1 B1
Feeder
Time axis
t=0 t=t
1
t=t
2
t=t
3
ANSI05000132 V1 EN
Figure 328: Selectivity steps for a fault on feeder B1
where:
t=0
is The fault occurs
t=t
1
is Protection B1 trips
t=t
2
is Breaker at B1 opens
t=t
3
is Protection A1 resets
In the case protection B1 shall trip without any intentional delay (instantaneous). When
the fault occurs the protections pickup to detect the fault current. After the time t
1
the
protection B1 send a trip signal to the circuit breaker. The protection A1 starts its delay
timer at the same time, with some deviation in time due to differences between the two
protections. There is a possibility that A1 will pickup before the trip is sent to the B1 circuit
breaker. At the time t
2
the circuit breaker B1 has opened its primary contacts and thus the
fault current is interrupted. The breaker time (t2 - t1) can differ between different faults.
The maximum opening time can be given from manuals and test protocols. Still at t
2
the
timer of protection A1 is active. At time t
3
the protection A1 is reset, that is the timer is
stopped.
In most applications it is required that the times shall reset as fast as possible when the
current fed to the protection drops below the set current level, the reset time shall be
minimized. In some applications it is however beneficial to have some type of delayed
reset time of the overcurrent function. This can be the case in the following applications:
1MRK 511 365-UUS A
Section 24
Inverse time characteristics
Phasor measurement unit RES670 2.1 ANSI 833
Technical manual