3Com S7906E - Switch, Руководство по настройке

Страница: 2255 / 2621

1-7
z
For the configuration of Track-Static Routing collaboration, the specified static route can be an
existent or nonexistent one. For an existent static route, the static route and the specified track
entry are associated directly; for a nonexistent static route, the system creates the static route and
then associates it with the specified track entry.
z
The track entry to be associated with the static route can be a nonexistent one. After you use the
track command to create the track entry, the association takes effect.
z
If the track module detects the next hop reachability of the static route in a private network through
NQA, the VPN instance name of the next hop of the static route must be consistent with that
configured for the NQA test group. Otherwise, the reachability detection cannot function properly.
z
If a static route needs route recursion, the associated track entry must monitor the next hop of the
recursive route instead of that of the static route; otherwise, a valid route may be considered
invalid.
z
For details of static route configuration, refer to Static Routing Configuration in the IP Routing
Volume .
Displaying and Maintaining Track Entries
To do… Use the command… Remarks
Display information about the
specified track entry or all track
entries
display track
{ track-entry-number | all }
Available in any view
Track Configuration Examples
VRRP-Track-NQA Collaboration Configuration Example (The Master Monitors the
Uplink)
Network requirements
z
As shown in Figure 1-2 , Host A needs to access Host B on the Internet. The default gateway of
Host A is 10.1.1.10/24.
z
Switch A and Switch B belong to VRRP group 1, whose virtual IP address is 10.1.1.10.
z
When Switch A works normally, packets from Host A to Host B are forwarded through Switch A.
When VRRP finds that there is a fault on the uplink of Switch A through NQA, packets from Host A
to Host B are forwarded through Switch B.