3Com S7906E - Switch, Руководство по настройке

Страница: 1734 / 2621

2-4
Suppose the logical relationship between classification rules is and . Note the following when using the
if-match command to define matching rules.
z
If multiple matching rules with the acl or acl ipv6 keyword specified are defined in a class, the
actual logical relationship between these rules is or when the policy is applied.
z
If multiple matching rules with the customer-vlan-id or service-vlan-id keyword specified are
defined in a class, the actual logical relationship between these rules is or .
The matching criteria listed below must be unique in a traffic class with the operator being AND .
Therefore, even though you can define multiple if-match clauses for these matching criteria or input
multiple values for a list argument (such as the 8021p-list argument) listed below in a traffic class, avoid
doing that. Otherwise, the QoS policy referencing the class cannot be applied to interfaces
successfully.
z
customer-dot1p 8021p-list
z
destination-mac mac-address
z
dscp dscp-list
z
ip-precedence ip-precedence-list
z
service-dot1p 8021p-list
z
source-mac mac-address
z
system-index index-value-list
To create multiple if-match clauses or specify multiple values for a list argument for any of the matching
criteria listed above, ensure that the operator of the class is OR .
Defining a Traffic Behavior
To define a traffic behavior, you must first create it and then configure QoS actions such as priority
marking and redirect in traffic behavior view.
Follow these steps to define a traffic behavior:
To do… Use the command… Remarks
Enter system view system-view —
Create a traffic behavior and
enter traffic behavior view traffic behavior
behavior-name
Required
Configure other actions in the
traffic behavior
Refer to the subsequent sections depending on the purpose of the
traffic behavior: traffic policing, traffic filtering, traffic redirecting,
priority marking, traffic accounting and so on.