ZyXEL Communications VSG1432-B101 - V1.10, Manual

Page: 31 / 408

Chapter 1 Introducing the VSG1432-B101
VSG1432-B101 Series User’s Guide
31
1.8 The RESET Button
If you forget your password or cannot access the web configurator, you will need
to use the
RESET button at the back of the device to reload the factory-default
configuration file. This means that you will lose all configurations that you had
previously and the password will be reset to “1234”.
1
Make sure the POWER LED is on (not blinking).
2
To set the device back to the factory default settings, press the RESET button for
ten seconds or until the POWER LED begins to blink and then release it. When the
POWER LED begins to blink, the defaults have been restored and the device
restarts.
1.9 Wireless Access
The ZyXEL Device is a wireless Access Point (AP) for wireless clients, such as
notebook computers or PDAs and iPads. It allows them to connect to the Internet
without having to rely on inconvenient Ethernet cables.
You can configure your wireless network in either the built-in Web Configurator, or
using the WPS button.
Figure 6 Wireless Access Example
1.9.1 Using the WLAN/WPS Button
If the wireless network is turned off, press the WLAN/WPS button on the front of
the ZyXEL Device for one second. Once the WLAN/WPS LED turns green, the
wireless network is active.
You can also use the WLAN/WPS button to quickly set up a secure wireless
connection between the ZyXEL Device and a WPS-compatible client by adding one
device at a time.