ZyXEL Communications P-660HN-F1A, User Manual

Page: 147 / 430

Chapter 8 Wireless LAN
P-660HN-F1A User’s Guide
147
8.2.1 No Security
In the Network > Wireless LAN > AP screen, select No Security from the
Security Mode list to allow wireless devices to communicate with the P-660HN-
F1A without any data encryption or authentication.
Note: If you do not enable any wireless security on your P-660HN-F1A, your network
is accessible to any wireless networking device that is within range.
Figure 47 Network > Wireless LAN > AP: No Security
The following table describes the labels in this screen.
8.2.2 WEP Encryption
Use this screen to configure and enable WEP encryption. Click Network >
Wireless LAN to display the AP screen. Select Static WEP from the Security
Mode list.
Note: WEP is extremely insecure. Its encryption can be broken by an attacker, using
widely-available software. It is strongly recommended that you use a more
effective security mechanism. Use the strongest security mechanism that all the
wireless devices in your network support. For example, use WPA-PSK or
Cancel Click this to restore your previously saved settings.
Advanced
Setup Click this to display the Wireless Advanced Setup screen and edit more
details of your WLAN setup. See
Section 8.2.5 on page 151 for more
details.
Table 30 Network > Wireless LAN > AP
LABEL DESCRIPTION
Table 31 Network > Wireless LAN > AP: No Security
LABEL DESCRIPTION
Security
Mode Choose No Security from the drop-down list box.