ZyXEL Communications P-660HN-F1A, User Manual

Page: 108 / 430

Chapter 6 WAN Setup
P-660HN-F1A User’s Guide
108
The following table describes the labels in this screen.
Table 19 Network > WAN > Internet Access Setup
LABEL DESCRIPTION
Line
Modulation
Select the modulation supported by your ISP.
Use Multi Mode if you are not sure which mode to choose from. The
P-660HN-F1A dynamically diagnoses the mode supported by the ISP
and selects the best compatible one for your connection.
Other options are ADSL G.dmt, ADSL2, ADSL2+, ADSL2 AnnexM,
ADSL2+ AnnexM, READSL2 Mode, ANSI T1.413 and ADSL G.lite.
General
Mode
Select Routing (default) from the drop-down list box if your ISP gives
you one IP address only and you want multiple computers to share an
Internet account. Select Bridge when your ISP provides you more
than one IP address and you want the connected computers to get
individual IP address from ISP’s DHCP server directly. If you select
Bridge, you cannot use Firewall, DHCP server and NAT on the P-
660HN-F1A.
Encapsulation Select the method of encapsulation used by your ISP from the drop-
down list box. Choices vary depending on the mode you select in the
Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC
1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483,
ENET ENCAP or PPPoE.
User Name (PPPoA and PPPoE encapsulation only) Enter the user name exactly as
your ISP assigned. If assigned a name in the form user@domain
where domain identifies a service name, then enter both components
exactly as given.
Password (PPPoA and PPPoE encapsulation only) Enter the password associated
with the user name above.
Service Name (PPPoE only) Type the name of your PPPoE service here.
Multiplexing Select the method of multiplexing used by your ISP from the drop-
down list. Choices are VC or LLC.
This field is not available if you set the WAN type to Ethernet.
Virtual Circuit ID VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define
a virtual circuit. Refer to the appendix for more information.
These fields are not available if you set the WAN type to Ethernet.
VPI The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
VCI The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for
local management of ATM traffic). Enter the VCI assigned to you.