Copyright(C)2012ZeroUAV
All Rights Reserved
25
in any time (including before takeoff or manual/auto mode after takeoff)
fly/take the craft to the target point to be the locked , then within 3 seconds
switch between position1 and position3 on CH6 for three times(that is
1->3->1->3->1->3->1 ), FC will record the longitude&latitude of GPS where
the craft locates as the target point to be locked.
Step
Step
Step
Step2
2
2
2::::
in GPS auto-hover mode, within 3 seconds switch between position1 and
position2 on CH6 for three times(do not switch to position3 which is invalid, that
is 1->2->1->2->1->2->1 ), then FC will enter target lock mode.
Tips:
After locking the target with solution1 or solution2, users can operate by
transmitter or by RC mode on phone.
Remark1: When left aileron outputs in RC interface, the aircraft will hover
clockwise around the target point. When the right aileron outputs, it will hover
anti-clockwise.
Remark2: Pushing the stick can decrease the hovering radius and drag the stick
can increase the hovering radius.
Remark3: After selecting
“Quit FlytoPP/PTZ Lock”
in "Tools” page or switch back
to manual mode, the elevator operation and aileron operation will be normal.
User can switch to manual mode and immediately back to GPS mode to continue
the operation.
（
7
7
7
7
）
Waypoints
Waypoints
Waypoints
Waypoints Flying
Flying
Flying
Flying
Step1:
Step1:
Step1:
Step1:
In Map page of GCS, click
“tools”
->
" Design waypoints"
to make the waypoints.
One click on map once can get one waypoint, get all waypoints one by one. Click
“Default Tool”
to complete the waypoints design.
Tips:
If the firmware version is later than Sept.15th,2012, each waypoint contains
