Copyright(C)2012ZeroUAV
All Rights Reserved
9
S
S
S
STEP
TEP
TEP
TEP3
3
3
3
After rotating, in settings page click on
Magnetic Compass
---
save Magneti
c
Compass
--
-OK.
After you finish the calibration, the GCS will go to
"Control"
interface automatically. After waiting for scores of seconds
（
the purple light
keeps going on during data reading
）
, mobile will display the magnetic sensor
data of AP, only look the red and blue circle in the middle of cross coordinates,
if they are close to standard round, then indicates a successful calibration and
data in good condition.
Two round circles will show whether the calibration was successful or not:
If two round circles show up in the
"Control"
interface (one blue circle one red
circle), calibration succeeds, can exit ;
If no circle or only one circle shows up in the
"Control"
interface, the calibration
has failed. Enter calibration by selecting
" Horizontal Asignment"
and then
re-start from step 1for re-calibration.
Successful Calibration Image:
Tips
：
After correct assembly and successful magnetic compass calibration once, no
need to recalibrate without any constructional reconfiguration or only upgrade
the firmware.
