Yamaha wr250f, Owner'S Service Manual

Page: 210 / 912

2 - 117
SPEC
CABLE ROUTING DIAGRAM
È
Fasten the start switch lead to the handlebar with the plastic
bands.
É
Fasten the engine stop switch lead and clutch switch lead to
the handlebar with the plastic bands.
Ê
Pass the brake hose through the hose guides.
Ë
Secure the coupler by inserting it into the multi-function display
bracket.
Ì
Pass the throttle cables, clutch cable and hot starter cable
between the upper bracket and multi-function display bracket.
Í
Fasten the multi-function display leads to the bracket. Cut off
the tie end.
Î
Secure the coupler by pushing it into the hole in the multi-func-
tion display bracket.
Ï
Secure the wire harness clip by pushing it into the hole in the
multi-function display bracket on the inside.
Ð
Fasten the wire harness to the multi-function display bracket.
Cut off the tie end.
Ñ
Fasten the main switch lead (wire harness side) to the multi-
function display bracket. Locate the clamp end facing toward
the lower side of the frame and cut off the tie end.
Ò
Pass the speed sensor lead through the guide on the outside
of the front fork.
40˚
±10
˚