109
Functions Used
As Needed
Set Mode
Tips
• The display changes as follows depending on the type of the power supply used.
Battery pack: “Lit”
Battery case: “Dry”
External power supply adapter: “Ext”
• During mono band reception, the voltage can be displayed on the LCD constantly (See page 27).
• This function displays the temperature inside the transceiver.
• In a situation where the temperature inside of the transceiver does not rise (e.g., standby reception),
you can know the approximate outside temperature from the temperature displayed on the LCD.
Changing the Display Pattern of the PO Meter
You can select a display pattern of the S/PO meter from among four types.
Enter the Set mode:
1
Press and hold
M
for over 1 second.
2
Turn
O
to select [1 DISPLAY].
3
Press
H
.
4
Turn
O
to select [11 S-METER SYMBOL].
5
Press
H
.
6
Turn
O
to select a display pattern.
/
/
/
Remark
Default:
7
Press
p
to save the selected display pattern, and exit
from the Set mode.
Switching between AM Antennas
You can switch antennas when listening to AM broadcast stations.
For details, see “Switching between AM Antennas” on page 33.
Reducing receiver sensitivity
Attenuator (ATT) Function
If the signal from the remote station is too strong or, a strong signal is present nearby
that interferes with reception, use the attenuator (ATT) function.
Enter the Set mode:
1
Press and hold
M
for over 1 second.
2
Turn
O
to select [2 TX/RX].
3
Press
H
.
FT1DR̲DE̲Eng.indb 109
FT1DR̲DE̲Eng.indb 109
13/06/28 15:17
13/06/28 15:17