60
Scanning Function
Using the Scanning Function
Tips
•
Turn
O
clockwise.: Scanning is performed toward higher memory channel numbers.
Turn
O
counterclockwise: Scanning is performed toward lower memory channel numbers.
•
When a signal is received during scanning, scanning stops for 5 seconds and this frequency
is received.
•
When scanning is suspended, the decimal point blinks and the LCD stays lit.
•
After receiving the frequency for 5 seconds, scanning resumes.
•
To stop scanning, press
p
.
Tips
• Even during scanning, you can adjust the squelch in the following procedure:
Press
F
Press
T
. Turn
O
to adjust the squelch.
• During scanning, you can finish the squelch adjustment in the following procedure:
Press
F
Press
T
.
• When a memory channel is recalled, the regular memory channels (memory channel numbers
1-900) are scanned.
• When a memory bank is recalled, only the memory channels in the memory bank are scanned.
• For the operation to perform when scanning stops, see [Selecting a Reception Method When
Scanning Stops] on page 59.
• Press and hold
M
over 1 second to select the Set mode option, and then select the following
setting items for more convenient use:
[8 CONFIG] [3 BEEP] [EDGE]: Emits a beep when the frequency band edge is reached.
[8 CONFIG] [3 BEEP] [SELECT]: Prevents a beep from being emitted when scanning stops.
[5 SCAN] [2 SCAN LAMP]: Prevents the LCD from being lit when scanning stops.
[5 SCAN WIDTH] [5 SCAN]: Range for scanning can be selected.
Specifying a Skip/Selected Memory Channel
You can specify two types of memory channels, a skip memory channel and a selected
memory channel, for effective memory channel scanning.
Skip memory channel: You can specify a memory channel that need not be scanned
during memory channel scanning.
Selected memory channel: You can specify selected memory channels so that only
the specific memory channels are scanned during memory
scanning.
1
Switch to the Memory mode, and then recall the memory
channel you want to specify as a skip memory channel or a
selected memory channel.
2
Press and hold
M
over 1 second.
Enters the Set mode.
3
Turn
O
to select [3 MEMORY].
4
Press
H
.
5
Turn
O
to select [5 MEMORY SKIP].
6
Press
H
.
7
Turn
O
to select [OFF], [SKIP], or [SELECT].
8
Press
p
to save the setting and exit from the Set mode.
FT1DR̲DE̲Eng.indb 60
FT1DR̲DE̲Eng.indb 60
13/06/28 15:16
13/06/28 15:16